You may feel intimidated by visiting lumber yard especially if you are new to woodworking. Chances are, you wouldn’t know what you want, and this will only make it harder for you to ask for a particular product and you will easily feel out of place. At a lumber yard, you may find a variety of products that may not be found at a home center. Lumber yards will arrange lumber in stacks depending on their species, and they may go as high as the ceiling. Reclaimed lumber from old buildings and barns can also be found at a lumber yard. The wide variety of products to choose from makes it difficult to settle for particular lumber since you may not know the exact product you are getting. Here, you can read about the best ways to select the best lumber yard.
Find out about the thickness of their lumber since this is the dimension used to categorize lumber. Depending on the size of the lumber when it is cut at the sawmill, some standard thicknesses have been established in which wood is sold. A one-inch lumber will be called a four-quarter since the thickness is measured in quarters which are quarter-inch increments. You should remember that boards are never perfectly flat. If you intend to have a board that will measure one inch after refining, you should get one that is a bit thicker than this and plane it down. If There is an up in it, you will have no other option but to remove material on both faces t make it even and parallel.
Look at their pricing policy. Most lumberyards will sell lumber by volume measured in units called board feet. To find the board feet, you multiply the width of a board by the length by the thickness (all measurements are in inches) and then dividing the final result by 144 which is a constant value.
Determine the kind of surfacing you want. There are two main types of surfacing namely rough surfacing and dressed surfacing. Lumber with rough surfacing is straight from the sawmill with a rough and uneven surface. If the lumber has gone through a plane, is said to be dressed. A board that is said to be designated S2S is surfaced on two parallel sides while one with all four sides surface is called S4S. When buying surfaced lumber, you may have to pay a little more money.